Automatic Horizontal Enamelling Machine

.Automatic Horizontal Enamelling Machine 2.Wire Range:0.08-0.25mm 3.Speed :310MPM. 4.No.of Lines :24

Enameling Machine SPECIFICATION

 

I. Technical specification of equipment

1.      Wire rangeΦ0.08Φ0.25mm

2.      Mechanical speed310m/min (max)

3.      Wire pitch7mm

4.      Enamel application method Felt

5.      No. of passes per line 8

6.      No. of line 24

7.      Take up methodSemi-automatic spool changeover

8.      Suitable take-up spoolPT4-PT25

9.      Suitable pay off spoolΦ240Φ300

10.  Installed electric power115KW

II. Component of equipment parts

The plant consists of pay off device (dynamic model & platform model), softening oven, fore and rear stand of sheaves, hot air circulation oven, take-up device and electric control board etc.

1. Payoff

1.1 Φ240-Φ300 iron spool, damping wisk type pay off device was adopted.

1.2 Platform model with water cleaning device.

2. Softening oven

2.1 Slant water seal with steam protection were adopted to prevent oxidation of copper wire and has blow-drying and baking device.

2.2 The effective length of softening oven is 5400mm, 28 stainless steel pipes (Φ14×2), its maximum temperature is 650.

2.3 One set of steam generator with electric heating fitted with alarm of low water level.

2.4 PID temperature control instrument was adopted for softening oven; the control is divided into two points (at fore and rear).

2.5 Separate left and right controls were used for speed-assisting device of wire inlet of softener.

Automatic Horizontal Enamelling Machine